المحرر موضوع: هاير غسالة إصلاح أبو ظبي  (زيارة 56 مرات)

0 الأعضاء و 1 ضيف يشاهدون هذا الموضوع.

غير متصل kmalramisamer

  • عضو مميز
  • ****
  • مشاركة: 1220
  • منتديات عنكاوا
    • مشاهدة الملف الشخصي
هاير غسالة إصلاح أبو ظبي
« في: 20:34 28/09/2019 »
Haier Washing Machine Repair Abu Dhabi

7 easy solutions to common washing machine problems
Washing machines are essential to any busy household, so when they break it's important they're quickly fixed. Here are seven easy solutions to washing machine problems you may face. Danet Abu Dhabi Washing Machine Repair
1. Washer won't run?
  • No power to unit-    double check that the washer is plugged into a functioning power   source.
  • Make sure the   cycle-selection knob is in the correct position.
2. Is your motor overheated?
  • Check for blown   fuse or tripped circuit breaker; make sure unit is securely plugged   in.
  • Make sure lid is   closed.
  • Make sure knob is   in correct position and pulled out for operation.
  • Wait for motor to   cool.
  • Call for service if   machine still won't start.
3. Machine fills with water but won't start?
This might be a faulty lid switch.  Gate City Abu Dhabi Washing Machine Repair Abu Dhabi
  • Turn on washer; lid   switch is located in small hole by the tub opening and is activated   by small lever on the lid.
  • Stick pencil in   hole; if machine starts running, replace the lever. If it doesn't   run, switch is faulty and needs to be replaced.
4. Washtub won't spin?
This could be because of an unbalanced load, a faulty transmission, or a loose drive belt.
  • Open lid and   rearrange laundry in tub.
  • If the washer is   still not spinning, call for service and replace or repair   transmission or drive belt.
5. Washtub fills too slowly?
There are a few reasons why your washtub may be filling slowly:
  • Water valves may   not be fully open: Open   valves fully (on single-lever valve systems, make sure lever is in   "on" position).
  • Hoses may be   kinked or blocked:   Straighten any kinks. To unblock, shut off water to machine and   unscrew hoses from back of machine. Remove obstructions, and   clean and rinse any clogged filters.
  • Low water   pressure: Don't   use water in other areas of house while washer is running.
6. Water temperature too hot or too cold?
If your water temperature is too hot or too cold, it could be because:
  • The water valves   not open equally or are reversed: Open   valves equally, and switch if reversed.
  • The water heater   temperature may be set too low:   If water entering machine is less than 50°C (120°F) (use a meat or   candy thermometer to measure), raise thermostat slightly.
  • The water may be   cooling on way to washing machine:   Insulate hot water pipe supplying washing machine.
7. Machine won't agitate?
If your machine won't agitate, it might be because:
  • Clothing caught   under agitator: Remove   clothing from agitator.
  • Blocked   pump: Free   obstruction to pump or replace pump.
  • Faulty lid   switch, timer, drive belt, solenoid or transmission:   Test and replace any faulty parts; call for service if the machine   still won't agitate. Haier   Washing Machine Repair Abu Dhabi
Washing machines can be problematic, but the solution might be easier than you think. Before you call for a repair, try to resolve the problem by trying one of these easy solutions.